|
|
|
More to the point, stop worrying about whether your "Atlanta bot" got screwed over or whatever. Worry about whether you've got an "Atlanta team."
- RebelWithARobot [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
|
More to the point, stop worrying about whether your "Atlanta bot" got screwed over or whatever. Worry about whether you've got an "Atlanta team."
- RebelWithARobot [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
CAD mount for a bearing to be used as a wheel.
I am attempting (without much success) in designing a mount for a load-bearing bearing. The mount should go on the weird-looking, upside-down T piece inside the long bar (see attached). The bearing is to be placed so that the weird piece can roll inside the long bar.
 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode