|
|
|
 I had a few jokes about the illness and germs at some of the competitions, but I don't want to spread them around. - tsaksa [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I had a few jokes about the illness and germs at some of the competitions, but I don't want to spread them around. - tsaksa [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#14
18-11-2015, 15:52
|
||||
|
||||
|
Re: Possible to extend output shaft on WCP Gearbox?
If you run those calculations with the kit drive train pulley sizes and wheel diameters, does a 9mm or 15mm belt meet the strength requirements? Is pulley size the only way to get a drive system from failing?
What happens if all the weight of the robot rocks on two wheels? What happens if all the weight of the robot rocks on one wheel? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode