|
|
|
 The manual can be compared to a textbook in school. If you choose not to use your textbook, you are asking to fail classes. - dez250 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The manual can be compared to a textbook in school. If you choose not to use your textbook, you are asking to fail classes. - dez250 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
26-11-2015, 02:46
|
|||
|
|||
|
[FTC]: Continuous Servo Keeps Rotating
Update: the issue was that the servo was plugged into port 6 but was programmed on the phone for port 1. The servo now works and stops at 0.5.
However, this brings up another question: why did the servo move even though no instructions were given to it (as per the phone)? Is this expected? Thanks, Charging Champions 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode