|
Re: How to use encoders
The example I listed does not deal with that application but there is an example called "CAN Talon Speed Control Encoder" that does address that. The front panel in the labview VI has the instructions.
Just a reminder, when you run these examples, even though you may not have a full robot hooked up, you still need to run a drivers station and enable teleop for them to work. It is in the instructions, but many people seem to overlook this step.
EDIT: this example can be found under the "CAN" sub-folder for the roborio.
__________________
The sooner we get behind schedule, the more time we have to catch up.
Last edited by tr6scott : 04-12-2015 at 11:59.
Reason: Added location
|
Scrap it and use the cheesey poof's design - vladtheimpaled [more] 
04-12-2015, 11:14
Threaded Mode