|
|
|
 I don't care if you use hot dogs for wheels. If you're scoring points, and you fit the strategy, it's fine. - evanperryg [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I don't care if you use hot dogs for wheels. If you're scoring points, and you fit the strategy, it's fine. - evanperryg [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
07-12-2015, 14:56
|
||||
|
||||
|
Re: Vapor polishing 3d printed parts
Tetrahydrofuran and M.E.K. can smooth PLA. I've used M.E.K. but it tends to take a long time with Inland generic PLA spools (there are different formulations of PLA so be aware that not all PLA is the same). I would strongly urge anyone considering these chemicals to use them near ventilation
 I should add - Tetrahydrofuran and M.E.K. make short work of latex gloves. Were suitable gloves when handling. Last edited by techhelpbb : 07-12-2015 at 18:05. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode