Quote:
Originally Posted by FTC Team CC
Just printed the Thingiverse PDM file (link above) and it looked like the scaling was off. When you print, you have to make sure to scale the part such that length is 10.41 cm.
|
3D printers have to be calibrated to get the correct lengths for longer parts. I'm guessing that, since no one else has complained about this problem for this part, your printer may be slightly out of calibration. That would also explain why the smaller parts are OK but longer parts are off a bit.
You might want to print a calibration test like the one below, measure the lengths precisely with calipers, and see if the lengths are correct. If they aren't, recalibrate and try again until the lengths are very close to correct.
http://www.thingiverse.com/thing:28109
One of those things I learned in kindergarten - never introduce myself to an “enraged” woman wielding a clipboard. - Mark McLeod [more] 
Hybrid Mode
