|
|
|
 Do not interrupt, do not defend yourself - just listen. After they are done, be sure to thank them for their honest feedback, and close the books. Arguing or defending is not how to accept feedback. - DonRotolo [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
T-Shirt Cannon
Hi Chief Delphi community,
I've been working on a T-Shirt cannon base for the past few days and I was wondering about how to plumb it. I'm using 2 scuba tanks as storage and firing chambers and I'm planning to tap threads into a custom pressure block that attaches to the barrel. Thanks in advance to anyone who has insight  Specs: 4 Cim drive 3/16in center drop WCD 360 degree rotation (shoot in any direction relative to wheels) Angle adjust from 45 to -45 (barrel facing down) 2.875in ID Barrel Magazine fed with cylinder ejection Last edited by fatmandandan : 21-12-2015 at 13:02. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode