Cube and Cubify to go away

[BenGuy]

Originally Posted by cbale2000

From what I understand, the bypass is possible on 2nd gen Cube is because of an older firmware version, if you update the firmware, the bypass isn't possible anymore. Consequently, I would assume as the eckocycle is a much newer printer, they likely shipped with a set of firmware that already included this fix.

That said, I don't have one of these printers either so I cannot confirm this either.

I think it should still be possible as it is totally hardware, no software at all, the only way that the Cube knows that something is installed is by a sensor in the bracket, if you leave an empty one there and just have a large and cheaper supply next to it, it should work perfectly fine as long as the stepper can pull it in well.