|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
|
||||||
|
||||||
|
Re: Sonic Shifter - recent feedback?
BoilerMentor,
Were you guys using the old ball shifter shaft without the pin in it or the new shaft? I ask because the press fit in the original shaft would allow the deflection you speak of but the new shaft would most definitely not. Also, a cantilevered shaft with the proper bearing spacing behind it is a perfectly legitimate design strategy especially with the cantilevered gear so close to the external bearing face. Additionally, this is the first example of a failure like this that we have seen with the 3 CIM shifter so I really would like to get more information from you. PM me if you would like me to email you. Again, this failure mode is not normal in the typical 3 CIM ball shifter use case (even with your ratios you are within our normal use case). Thanks, Paul |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|