|
Re: 2016 Beta Software Access
It's based on the IP address you gave the OpenMesh, e.g., 10.te.am.1
The OpenWRT page for the details looks like the attached. That page starts serving DHCP IP addresses at .100
To test if this is a problem in your setup you can replace the OpenMesh with an old house AP router in your network setup just to serve DHCP addresses to everyone.
Set the router's IP (10.te.am.1), an SSID you like, and DHCP to serve IP addresses at .20 or higher.
You'll have the FRC versions of everything on Saturday.
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 06-01-2016 at 12:39.
|
Basically: engineering is fun. - Mike [more] 
06-01-2016, 12:03
Threaded Mode