Big Shaft to Little Shaft? - Chief Delphi

Go to Post

I thought we agreed to just put up a teaser, not a picture of the robot! - IBdrummer [more]

Home

		Chief Delphi > Technical > Technical Discussion
Big Shaft to Little Shaft?

Mark Forums Read

Rate Thread

Prev

Previous Post

Next Post

Next

#1

Spotlight this post!

Unread

19-01-2002, 01:46

Anton Abaya Anton Abaya is offline

Anton Abaya is offline

Registered User

None #0419 (Rambots)

Join Date: Jun 2001

Rookie Year: 1999

Location: Boston

Posts: 215

Anton Abaya has a spectacular aura about

Anton Abaya has a spectacular aura about

Anton Abaya has a spectacular aura about

Send a message via ICQ to Anton Abaya

Send a message via AIM to Anton Abaya

Big Shaft to Little Shaft?

Whats the best way teams have connected a smaller diameter shaft to a larger diameter shaft. Say 5/16" to a 1/2" ? or a 3/8" to a 1/2"?

-anton

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can you stop a pneumatic pump at half shaft	mjt902	Pneumatics	16	06-02-2003 11:58
Curie Division Robots information... (not complete)	archiver	2001	3	24-06-2002 03:13
Team 188 Pictures - four big balls anyone?	archiver	2001	6	24-06-2002 01:03
Motor coupling	archiver	2001	19	23-06-2002 23:35
using set screw or dowel pin/pin to hold on drill motor coupler thinggy	Travis Covington	Motors	1	04-02-2002 03:02

All times are GMT -5. The time now is 14:59.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.