|
|
|
 If I was making this I would want to not have to use anything smaller than a 3/16" end mill, but 1/8" would be acceptable. Anything smaller and I'd tell the designer to go play in traffic. - Cory [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
That was why you were supplied with it
 . Sorry, but it is not a common pressure angle. The other part of the cluster _is_ a common gear and you can interface with it.This means that you will need access to machinery to mount the motor, the shaft for the gear cluster and at least one other cluster. You may have to to a machinist to have it done. Larry Barello posted a picture of a trial run he did, and some useful dimensions. Good Luck 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drill motor change out question?? | archiver | 2001 | 9 | 23-06-2002 23:36 |
| Is it weird to see an atwood motor floating in mid air? | mnkysp6353 | Chit-Chat | 6 | 19-02-2002 21:38 |
| What's with the New Motor Specs for the Atwood Mobile (Chiaphua) Motor. | Robb Gerber | Motors | 2 | 23-01-2002 08:58 |
| question about atwood motor | matt sorgenfrei | Motors | 0 | 18-01-2002 23:19 |
| Drill motor gearBox question | Dennis Hughes | Motors | 4 | 11-10-2001 07:11 |
Hybrid Mode
