Bridge Configuration Utility not available in suite?

[RufflesRidge]

Originally Posted by team-4480

Was there a new update for the RIO? When I fired up the utility, I only saw the 2015 rev23 image.

Make sure you've installed the 2016 update and are in the LabVIEW 2015 folder. You should see 2016v19.

[team-4480]

Originally Posted by RufflesRidge

Make sure you've installed the 2016 update and are in the LabVIEW 2015 folder. You should see 2016v19.

I think I might have forgotten to completely unzip the update. I think I stopped because it wanted my password so I put in the same password I used to open the downloader, and it didn't work(the serial number in the KoP).

[RufflesRidge]

Originally Posted by team-4480

I think I might have forgotten to completely unzip the update. I think I stopped because it wanted my password so I put in the same password I used to open the downloader, and it didn't work(the serial number in the KoP).

The encryption key for the update is the one from the kickoff video: @Ahead)Together!FRC^2016