|
|
|
 I personally think any student should be allowed to participate, as long as he/she is helpful and active. FIRST, to me, is about inspiration, not elitism. - Aignam [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Cleated Tread
I don't think you would have an issue. I used conveyor belt on one of our previous robots (2006 I believe). the issue you might run into is stitching the conveyor belt together at the ends. In industry this is typically done with a crimp on 'lace' with a stainless wire used as the pin.
http://images.drillspot.com/pimages/...359590_300.jpg |
|
#2
15-01-2016, 15:37
|
||||
|
||||
|
Re: Cleated Tread
I would guarantee that this stuff was actually conveyor belt long before it was wheel traction material.
http://www.simbotics.org/sites/all/t...lity-ben-1.png |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
