|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
||||
|
||||
|
Re: Cleated Tread
I don't think you would have an issue. I used conveyor belt on one of our previous robots (2006 I believe). the issue you might run into is stitching the conveyor belt together at the ends. In industry this is typically done with a crimp on 'lace' with a stainless wire used as the pin.
http://images.drillspot.com/pimages/...359590_300.jpg |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|