|
|
|
 The unlived life is not worth examining; the unexamined life is not worth living. - Sage-Theory6 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The unlived life is not worth examining; the unexamined life is not worth living. - Sage-Theory6 [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Man, so far all of your questions are easily awnswered by the manual
Here is the info straight from it: Fasteners Fasteners, Washers, Nuts, Adhesives Any amount/size Joining Plates for Extrusions Any amount, Any size 5 Minute Epoxy Gel Rubber Band, Large 3-1/2” x 1/4” wide, Up to 5 Hose Clamps Any Ø, Any amount Pipe fittings (tees, reducers, elbows, angles) Any amount - to join sections of pipe Rubber Band, Small 3-1/2” x 1/8” wide, Up to 5 Pipe Endcaps Any amount - if used to cap pipes Pipe flanges Any amount - if used to attach pipes |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| plastic hubs and drill motors | Will Camisa | General Forum | 4 | 01-03-2003 00:03 |
| drill motor mounting | whynot | Technical Discussion | 3 | 03-02-2003 08:24 |
| new bosch pinion and mounting | ajlapp | Motors | 1 | 08-01-2003 17:16 |
| Mounting Drill Motors Using Plastic Housing | beakes | Motors | 3 | 31-01-2002 00:05 |
| Bosch Drill Motor Mounting | Josh Treisner | Motors | 3 | 11-10-2001 12:57 |
Hybrid Mode
