Roborio Image does not match plugin

[RufflesRidge]

Originally Posted by Bernstern

When i went to eclipse and checked for plugin updates, it said it was current and i validated with the FRC software site.

So you have the correct version of the plugins installed as confirmed with this page? http://wpilib.screenstepslive.com/s/...ware-revisions

If that's the case, for some reason the plugins must be failing to update the files. Close Eclipse, delete your C:\Users\USERNAME\wpilib directory (where USERNAME is your username), then open Eclipse again.

[Bernstern]

Originally Posted by RufflesRidge

So you have the correct version of the plugins installed as confirmed with this page? http://wpilib.screenstepslive.com/s/...ware-revisions

If that's the case, for some reason the plugins must be failing to update the files. Close Eclipse, delete your C:\Users\USERNAME\wpilib directory (where USERNAME is your username), then open Eclipse again.

Ok so that did the trick, now im getting error remote command failed exit status 1

[Arhowk]

Originally Posted by Bernstern

Ok so that did the trick, now im getting error remote command failed exit status 1

Deploy again. Without the entire console output, this error usually pops up because no robot code is running when it tries to cancel the current running code.

[RufflesRidge]

Originally Posted by Bernstern

Ok so that did the trick, now im getting error remote command failed exit status 1

Post the full contents of the console window please. That message is not particularly helpful by itself. It means one of a whole slew of remote commands run on the roboRIO failed. Some of them can fail harmlessly, others will prevent the build from continuing, but we can't tell which one failed or how to fix it without the whole log.

[jwatson12]

Make sure you are using this years FRCUpdates and that your RoboRio has the matching image.

[euhlmann]

Originally Posted by Bernstern

Ok so that did the trick, now im getting error remote command failed exit status 1

That should be safe to ignore. It tends to pop up when there is no robot program already on the rio (which causes the kill command to fail)

Deleting the wpilib directory and restarting eclipse solved the problem for me as well. You can also go into the build.xml file and just remove the assertion.

[BenD]

If you're receiving the error remote command failed exit status 1 but your code is going through and the program builds successfully, then there is no issue. euhlmann explains it well above.

If the error is causing your build to fail, make sure you have the correct JRE on the RoboRIO.