|
|
|
 If I can make one wish, it would be having Dean and Woodie read one of these writings of mine, so I can tell them "I get it! Give me time and give me inspiration, and one day I will be ready to take over the torch." - Ken Leung [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Build Works/ Deploy doesn't
I can build the Labview program I've written to our roboRIO, bur when I attempt to deploy the code it states "the network address might be invalid or the target is not responding" I don't know how to fix this though.
Any suggestions? 
|
|
#2
17-01-2016, 17:29
|
|||||
|
|||||
|
Re: Build Works/ Deploy doesn't
Have you tried using the USB cable?
Has the roboRIO has been setup for 2016 (firmware 3.0.0f0.cfg & image 2016_v19)? Can you browse to the roboRIO using IE or the modern equivalent? On the project explorer window check that it has the correct address for your team: Target (roboRIO-1769-FRC.local) Last edited by Mark McLeod : 17-01-2016 at 17:31.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
