Question about Actuators

[andyn2311]

I was wondering if this type of actuators will be accepted by the FRC?

http://www.amazon.com/Stroke-Linear-...2%22+actuators

Thanks

[EricH]

Not with the stock motor. You'd have to remove and replace the motor to be in compliance with the rules.

[andyn2311]

Thanks, a lot

[y-aji]

Out of curiosity, does anyone know of any electrical actuators that are compatible with any of the approved motor list? We need one w/ a 2" stroke and another one with a 8" stroke.. Both ideally about a 1/2" diameter rod and able to move... Well.. Unsurprisingly 120lbs minimum.

Thanks!

-yaji

[EricH]

Originally Posted by y-aji

Out of curiosity, does anyone know of any electrical actuators that are compatible with any of the approved motor list? We need one w/ a 2" stroke and another one with a 8" stroke.. Both ideally about a 1/2" diameter rod and able to move... Well.. Unsurprisingly 120lbs minimum.

Thanks!

-yaji

http://dartactuators.com/ are designed for CIM motors.

Other than that, you may have to do some engineering. This is, after all, an engineering challenge.

[y-aji]

... for kids.. an engineering challenge for kids..

But yes... thanks much! We'll look into dart.

-yaji