R54 and R69 motor control and PWM servos regards to the MXP port

Hmmm, the Michelangelo method of robot building. Just cut away anything that doesn't look like a robot. - GaryVoshol [more]

		Chief Delphi > Technical > Electrical
R54 and R69 motor control and PWM servos regards to the MXP port

18-01-2016, 09:34

Al Skierkiewicz Al Skierkiewicz is offline

Broadcast Eng/Chief Robot Inspector

AKA: Big Al WFFA 2005

FRC #0111 (WildStang)

Team Role: Engineer

Join Date: Jun 2001

Rookie Year: 1996

Location: Wheeling, IL

Posts: 10,795

Re: R54 and R69 motor control and PWM servos regards to the MXP port

Quote:

Originally Posted by cpapplefamily

So then using the PWM pin in the MAP or Standard PWM ports to drive a motor controller we only need two wires. ( signal and ground)

Yes, however, it is far easier (and more reliable) to use the three wire standard PWM cabling and connectors.

__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:40.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.