|
|
|
 20,000 students 900 teams robots Gracious professionalism = FIRST - Bcahn836 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| 20,000 students 900 teams robots Gracious professionalism = FIRST - Bcahn836 [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Bumper "Side" Clarification
If this is a top view, the edge of your FRAME PERIMETER is the 24 inch dimension and therefore you have to cover 8 inches on either side. The bumper shown would not be legal.
See this Q&A If in doubt, imagine pulling a string all the way around the outside of your robot. This defines your FRAME PERIMETER. Each of the sides of string now needs to have at least 8 inches of bumper on it, and each end of each bumper piece needs to be supported (at least 1/2 inch per R26). -matto- |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
