|
|
|
 Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Troubles with Labview 2015 (FRC)
My team and I have installed Labview using the disc given to us in the "NI Software for FRC 2016" package. When I open the Labview 2015 application on my computer this window pops up:
Not only does it look different from what I've seen throughout these forums and on the FRC resource library (https://wpilib.screenstepslive.com/s...-test-program), but it also doesn't seem to have an FRC RoboRIO project template. Any help would be very much appreciated! Thank You! 
|
|
#2
19-01-2016, 18:15
|
|||
|
|||
|
Re: Troubles with Labview 2015 (FRC)
Make sure to install the FRC Update Suite!
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
