|
|
|
| Let's swap data! |
![]() |
|
|||||||
|
||||||||
| View Poll Results: Was this helpful ? | |||
| Very Helpful. |
|
0 | 0% |
| Somewhat Helpful. |
|
9 | 64.29% |
| Not Helpful. |
|
5 | 35.71% |
| Voters: 14. You may not vote on this poll | |||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: 3D printing a Tank track.
Hi Brandon,
On the static question, that is a good point. We have not had any issues or noticed any static buildup and we do always trail a static strap. I will definitely look at that closer, all of our testing is on carpet. Best Regards, Colm. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|