Talon SRX not visible on CAN

[TimTheGreat]

Originally Posted by ozrien

It sounds like the BC calibration button is stuck it held down. Can u try press/releasing the BC cal button?

Yup the button was held down. Do you know what causes this? Is it the large bumps from going over obstacles?

[Al Skierkiewicz]

Tim,
I have not seen this occur in the past. It is mostly caused by a sharp object getting into the button and pushing it hard. Often a dropped tool.

[TimTheGreat]

Originally Posted by Al Skierkiewicz

Tim,
I have not seen this occur in the past. It is mostly caused by a sharp object getting into the button and pushing it hard. Often a dropped tool.

I don't remember seeing anything. Could it have been the screw that holds the breakout cable cover?

[Al Skierkiewicz]

Not in my experience.