|
|
|
 Consider that the 12V from your robot isn't any different from the 12V from your car's cigarette lighter. (Err... sorry... that's "power port" these days, thank goodness.) - dtengineering [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
AndyMark 3CIM4U with Rhino Track Output Shaft Issues
Hey all,
As we were putting together the Rhino Track, it became obvious that there is a problem with the output shaft on the 3CIM4U being too short. We double checked with CAD to make sure everything was assembled correctly and short of removing the thinner of the two plates on the 3CIM4U, it doesn't seem there is much we can do. Is anyone else using the combination of these two parts and having the same problem? Would appreciate some help. Thanks in advance.  Last edited by Bluman56 : 21-01-2016 at 21:01. Reason: image link |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode