Bumper dimension doubt - Chief Delphi

We don't use fancy tools like that, but we might need some wood glue or something :) - MrForbes [more]

		Chief Delphi > FIRST > General Forum
Bumper dimension doubt

Thread Tools

Rate Thread

Display Modes

22-01-2016, 08:06

Al Skierkiewicz Al Skierkiewicz is offline

Broadcast Eng/Chief Robot Inspector

AKA: Big Al WFFA 2005

FRC #0111 (WildStang)

Team Role: Engineer

Join Date: Jun 2001

Rookie Year: 1996

Location: Wheeling, IL

Posts: 10,792

Al Skierkiewicz has a reputation beyond repute

Re: Bumper dimension doubt

Bumpers are evaluated with respect to the corners of the FRAME PERIMETER. In the drawing above, there are four corners and each corner must have 8" of bumper on each side of the corner. If the side of the robot was less than 8" long, the entire side must be covered in bumper. The bumper is evaluated for length by measuring the backing board from the corner of the frame.
Please see the lower left drawing in Fig. 4-3 of the robot rules.

__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:59.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.