|
|
|
 The manual can be compared to a textbook in school. If you choose not to use your textbook, you are asking to fail classes. - dez250 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The manual can be compared to a textbook in school. If you choose not to use your textbook, you are asking to fail classes. - dez250 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
22-01-2016, 11:06
|
||||
|
||||
|
Also on that output shaft either make a spacer or what we did another 1/2" hex collar to press against the outer plate flange bearing. The flange bearing is "press fit " but will back out of the outer plate at least one of ours did.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode