Tuning PID - Chief Delphi

22-01-2016, 17:05

TimTheGreat TimTheGreat is offline

ArchdukeTim

FRC #1418 (Vae Victis)

Team Role: Programmer

Join Date: Jan 2013

Rookie Year: 2011

Location: Falls Church

Posts: 234

TimTheGreat has a spectacular aura about

Re: Tuning PID

Quote:

Originally Posted by Hitchhiker 42

After you tune your P value, tune the I until the arm gets about to where it should be. The D value may not be necessary at all (0).

How much do I increase it by? 1?

And how do I know when the P value is tuned? It seems to work, but is there a way I could make it work "better"?

__________________
There are two ways of constructing a software design: One way is to make it so simple that there are obviously no deficiencies, and the other way is to make it so complicated that there are no obvious deficiencies. The first method is far more difficult.

2012 - Gracious Professionalism - Greater DC
2014 - Regional Finalist - Virginia | Industrial Design - Virginia | Regional Finalist - Greater DC
2015 - Innovation in Control - Greater DC
2016 - District Event Winner - VAHAY | Innovation in Control - VAHAY | District Event Winner - MDBET | Industrial Design - MDBET | District Champion - CHCMP | Innovation in Control - CHCMP

Last edited by TimTheGreat : 22-01-2016 at 17:07.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:51.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.