AndyMark 3CIM4U with Rhino Track Output Shaft Issues

Thankfully, my student drivers are a lot smarter than me and covered for me on several occasions. - Paul Copioli [more]

		Chief Delphi > Technical > Technical Discussion
AndyMark 3CIM4U with Rhino Track Output Shaft Issues

Thread Tools

Rate Thread

Display Modes

#10

23-01-2016, 09:38

Dad1279

Registered User

FRC #1279 (Cold Fusion)

Team Role: Mentor

Join Date: Jan 2005

Rookie Year: 2004

Location: NJ

Posts: 511

Re: AndyMark 3CIM4U with Rhino Track Output Shaft Issues

I'm not sure it's a problem. The drive sprocket for the tracks are right next to the transmission, and the output shaft is supported at both ends by a bearing.

We used to use unsupported transmission shafts driving sprockets for years.

Last edited by Dad1279 : 23-01-2016 at 10:24.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:35.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.