|
|
|
 FIRST robots definitely meet many commonly agreed upon definitions of robots. Some will disagree. Good for them. In my opinion, it's not worth arguing over. - Mikell Taylor [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Can't connect to new DLink
I am using our new OM5P-AN dlink, but I can't connect because it won't even appear as an option to connect to. Usually if I had this problem in the past, I would reset the DLink, but there seems to be no manual reset on the new DLink. Any help appreciated!
|
|
#3
26-01-2016, 14:53
|
||||
|
||||
|
Re: Can't connect to new DLink
The OM5P-AN replaces the DLink for 2016 -- calling it the DLink might cause some confusion.
Have you run the FRC configuration program? Until you configure the OM5P-AN it's not set up for your team. If it's not from the KOP you'll have to update the firmware to the custom FRC firmware. Check under New for 2016 in the Getting Started... documentation: https://wpilib.screenstepslive.com/s/4485 I think this will take you directly to the right place: https://wpilib.screenstepslive.com/s...anual-id=13503 |
|
#4
26-01-2016, 14:56
|
|||||
|
|||||
|
Re: Can't connect to new DLink
Check out this link for instructions that you may find helpful. The only way to reset the new radio is to use this tool.
http://wpilib.screenstepslive.com/s/...o-for-home-use -Hugh |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
