Rookie team, wish I had that list!

I think that FIRST should just give up and officially recognize Chiefdelphi as the place to go for community and team resources. - Greg Needel [more]

		Chief Delphi > FIRST > General Forum
Rookie team, wish I had that list!

Thread Tools

Rate Thread

Display Modes

#10

27-01-2016, 20:32

Austin2046 Austin2046 is offline

Design, Strategy & Scouting Mentor

FRC #2046 (Bear Metal)

Team Role: Mentor

Join Date: Jan 2010

Rookie Year: 2007

Location: Maple Valley, WA

Posts: 175

Re: Rookie team, wish I had that list!

If you're going with the kitbot chassis and/or don't have a lathe than it may not be as important... but we use a lot of 1/2 inch hex shaft, 1/2 inch round flange bearings and 1/2 inch hex bearings... we use the shaft for our drive axles, collectors, shooters... anything that turns. Our first year we used round or keyed shafts, we did not know the wonders of hex shaft.

__________________
http://tahomarobotics.org/ http://www.facebook.com/#!/FRC2046

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 20:23.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.