|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Announcing findrobotparts.com
Great job folks. Very impressed.
|
|
#2
|
||||
|
||||
|
Re: Announcing findrobotparts.com
We appreciated all the feedback and after a couple of discussions we will be doing the following very soon:
Compressors Accumulators (Pneumatic Tanks) Only problem is we don't know where to get these besides the vendors we already list on the site. Where do you get them? Other changes we are making based on feedback is adding The Robot Space and more sensors. If there are any specific sensors you think are missing please post them. Thanks again for all the feedback. |
|
#3
|
|||
|
|||
|
Re: Announcing findrobotparts.com
Quote:
Also, about the 8mm sizing for the CIM motor shafts, I have found when I put a caliper on them that they are actually 5/16". Anyone else actually measure the shaft sizes for the CIM and mini-CIM? |
|
#4
|
|||
|
|||
|
Re: Announcing findrobotparts.com
Nice work!
Have you started an endless task? |
|
#5
|
||||
|
||||
|
Re: Announcing findrobotparts.com
We have added several of the updates that were supplied and also added The Robot Space. By the end of the weekend we hope to add a new category or two.
Apparently yes but it is a great value to the community so it is worth it. |
|
#6
|
||||
|
||||
|
Re: Announcing findrobotparts.com
I wasn't sure what the most effective way to represent this on the spreadsheet would be, but the VexPro VersaPlanetary is actually load rated for reductions up to 324:1 when using certain motors and output shafts on a 3-stage configuration.
See page 5 on this PDF for reference. |
|
#7
|
||||
|
||||
|
Re: Announcing findrobotparts.com
We have added a Wheels section and Compressors. We hope to launch a couple more sections tomorrow.
http://findrobotparts.com/wheels/ http://findrobotparts.com/pneumatics/compressors/ |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|