|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: mecanum wheel intake test
Why mecanum? It seems like you could do this with any wheels. What is the advantage?
|
|
#2
|
||||
|
||||
|
Re: mecanum wheel intake test
They have a component of motion that direct the ball to the cutout, which regular wheels do not have.
|
|
#3
|
|||||
|
|||||
|
Re: mecanum wheel intake test
Watch closer. It scoots the ball sideways along the bumper before feeding it into the cutout.
|
|
#4
|
||||
|
||||
|
Re: mecanum wheel intake test
Look back at 180 in 2014 and 179* in Recycle Rush. Both used mecanum in their gatherers and worked amazingly.
*Used on their can claw Last edited by dodar : 01-02-2016 at 22:41. |
|
#5
|
||||
|
||||
|
Re: mecanum wheel intake test
180 used them in 2014. The 2012 World Championship robot was a simple piece of PVC pipe painted red.
|
|
#6
|
||||
|
||||
|
Re: mecanum wheel intake test
You are correct. Got the years mixed up.
|
|
#7
|
||||
|
||||
|
Re: mecanum wheel intake test
1986 in 2014 comes to mind
|
|
#8
|
|||||
|
|||||
|
Re: mecanum wheel intake test
Quote:
|
|
#9
|
||||
|
||||
|
Re: mecanum wheel intake test
Cool! Good job guys!
|
|
#10
|
||||
|
||||
|
Re: mecanum wheel intake test
What is your spacing between mecanum wheels? We are finding some dead zones if we space them out too much.
Here's a picture from a few days ago. I'll try to get a video the next time we run it. Also, we are heavily considering printing hubs and using the purchased Vex rollers... It will bring down the cost a lot but not sure how this will hold up at competition. |
|
#11
|
||||
|
||||
|
Re: mecanum wheel intake test
1619 used these in 2014 as well. I know other teams did too; I mention 1619 since their 2014 robot has inspired about half of our design for this year (including the intake).
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|