MPU-9150 (I2C) with Labview

[RyanN]

Originally Posted by Ian R.

Hello everyone,

This year, our team decided to go ahead and use an extra motion tracking devide. We opted for the MPU-9150, but we are having problems getting it to work with Labview.
It is connected to the roboRIO's onboard I2C, and we based our Labview code on this Arduino example: http://playground.arduino.cc/Main/MPU-9150

After hours of trying to get a response from it, we haven't had any success. I'll upload the code later today

I used the MPU-9150 a few years ago on my senior design project for college. It was a pain in the butt to get the magnetometer working. The accelerometer and gyro were relatively easy though.

Please post your code and I'll take a look at it.