pic: Team 2053 Standard

[jreneew2]

loading photo ...

[RoboChair]

I don't think that this conforms to the rules laid out for team standards.

http://www.firstinspires.org/sites/d...ifications.pdf

[JohnGilb]

Are you concerned about this rule?

The horizontal support piece(s) length may not exceed 15” (762mm) in length and ½” (12.5mm) OD.

[RoboChair]

Originally Posted by JohnGilb

Are you concerned about this rule?

Primarily, yes.

[Bob Steele]

I really like your design.... very creative and plenty strong.
I do think that there may be a couple of issues with it.

If you win a ribbon how will you attach it?
The ribbons have grommets that will fit over 1/2" material. I believe the horizontal piece is supposed to reserve 1.5 inches at the end for them. If your frame comes apart I suppose you could put them in between the pipe frame and the standard. I do think the intention of the rule is that they would be able to fly on the outside.

I am not sure how the rules interpret the "standard"
I think there is a horizontal piece not to exceed 15" and a vertical piece not to exceed 32".

I would imagine that everything else is the standard itself

The rule states: The Standard substrate must be made of cloth or other flexible material.

The pipe frame you have is not cloth or other flexible material.

I am not trying to criticize I just think you should check and see. It would be a shame to get to an event and find out that your really cool standard could not be flown.

Again... very cool job.. I would not have thought to do a pipe frame like that