|
Re: PCM Solenoid Fuse
A quick look for "solenoid fuse fault" in the PCM manual didn't find a description of exactly what that means. I suspect that it is something internal to the PCM rather than the supply fuse. Perhaps the 12 volt solenoids are overdrawing the 24 V supply and disabling the solenoid outputs. If the fault was referring the PCM supply fuse, i think it would be worded differently.
I like connecting the PCM to a 20 amp breaker slot rather than the fused output. I read table 4.2 of rule R48 as allowing that.
__________________
If you don't know what you should hook up then you should read a data sheet
Last edited by FrankJ : 03-02-2016 at 08:44.
|
Let’s not scare the newbies away, let’s welcome them and help them.
- Arefin Bari [more] 
03-02-2016, 08:39
Threaded Mode