Glue shaft on back case of CIM motor

I'm pretty sure Andrew Baker and Andy Baker are the same person. Then again, Andy may just be holding out on us. - Amanda Morrison [more]

		Chief Delphi > Technical > Motors
Glue shaft on back case of CIM motor

Thread Tools

Rate Thread

Display Modes

03-02-2016, 11:38

rod@3711

Registered User

AKA: rod nelson

FRC #3711 (Iron Mustangs)

Team Role: Mentor

Join Date: May 2014

Rookie Year: 2014

Location: Trout Lake, WA

Posts: 64

rod@3711 is an unknown quantity at this point

Re: Glue shaft on back case of CIM motor

Someone on the team asked if we could use the single axis gyro?

My immediate response was NO.

But we can always tilt our shooter back to a home position, then use the gyro to tilt to a shoot position (to minimize drift concerns). We might try that when we have a lot of time to waste.

I love simple, and a simple bracket and a hose clamps seems better than glue. Easier to repair when it breaks.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 22:22.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.