pic: Custom encoder mount for Mini CIM/CIM

There is a big difference between "we have not been able to figure out how to do it." and "it's impossible" or "don't even bother." Let's be constructive not discouraging. - PVCMike [more]

		Chief Delphi > ChiefDelphi.com Website > Extra Discussion
pic: Custom encoder mount for Mini CIM/CIM

Thread Tools

Rate Thread

Display Modes

05-02-2016, 15:27

iambujo

Mentor

FRC #2729 (Storm)

Team Role: Mentor

Join Date: Feb 2008

Rookie Year: 2008

Location: NJ

Posts: 84

Re: pic: Custom encoder mount for Mini CIM/CIM

Quote:

Originally Posted by jojoguy10

Actually, according to CUI's datasheet, the maximum RPM is 15,000RPM if you go down to 512PPR

Great design BTW! How much of the CIM shaft is left sticking out?

Right, it can go up to 15,000 RPM at a lower encoder resolution. I only quoted the range that a mini CIM or CIM could reach, but good catch.

I'll measure the final shaft length tomorrow and let you know.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:51.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.