|
|
|
 Competition and inspiration go hand in hand. Those who inspire will be pushed to do it again and again by those who see this as a healthy competition. Those who are inspired will compete to be an inspiration to others. You can have your cake (competition) and eat it (inspire) too.
- Andy Baker [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Questions Regarding Motors and Buttons
Hello! I'm having a bit of trouble with getting two motors (not used for driving) to be controlled with two buttons: one to move them clockwise, another button for counter-clockwise.
The two motors are Talon SRs, and they're both wired to separate PWM channels. Every time I enable the robot on the Driver Station, I'm confronted with errors 91 and -44007. Any ideas? How should I wire the motors in Teleop mode in Labview? 
|
|
#2
06-02-2016, 14:04
|
||||
|
||||
|
Re: Questions Regarding Motors and Buttons
Here's how I tried to do it in Teleop: https://www.dropbox.com/s/dvoa9qtq8o...61304.jpg?dl=0
|
|
#3
06-02-2016, 21:44
|
|||
|
|||
|
Re: Questions Regarding Motors and Buttons
To get more detail on most error codes, you can right click and choose Explain Error. Or you can go to the Help menu >> Explain Error and type in the #. It will tell you that -44007 means that the refnum name doesn't exist. This likely means that the string is spelled differently in Begin and TelelOp. It is case sensitive as well.
Greg McKaskle
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
