Drive Station not connecting to roboRIO

[fsilberberg]

Are you trying to run both driver stations at once? The robot will only connect to one of them, the first one it sees.

[mrbrenzo]

I have just troubleshot this to. I could ping, but not control the robot. we troubleshot using the following steps;
1. check ping
2. try to drive it by hooking your driver station to the radio with an cat5 cable. if that works, you have validated your network settings. if driving with the cat5 cable does not work it is a network setting.
ours worked when using the cable. turns out our wifi adapter on the driver station was so old, it would do the network settings, but could not support the bandwidth. good luck