Running the Labview Example CAN Talon Code

I'll toss this out to stir up the pot: if you need double precision floats for your FRC software, you should re-think what you're doing. - Ether [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Running the Labview Example CAN Talon Code

Thread Tools

Rate Thread

Display Modes

07-02-2016, 10:38

btcshields6 btcshields6 is offline

Registered User

FRC #4206

Join Date: Aug 2014

Location: Texas

Posts: 107

btcshields6 is an unknown quantity at this point

Re: Running the Labview Example CAN Talon Code

I did not have the robot enabled at the time I ran the example code. I didn't think that VIs run with Labview opened and when the robot was tethered were affected by the Driver Station...didn't have any basis for that so I don't know why I thought it.

I'll try again tomorrow, with the robot enabled in the DS, and the code running in Labview.

I'll check the brake/coast modes. Thank you!

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:22.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.