|
|
|
 You know you've overdosed on FIRST when you hear people yell "CHARGE" and you get confused and lost when you look and see baseball and not robots - thatphotochick [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You know you've overdosed on FIRST when you hear people yell "CHARGE" and you get confused and lost when you look and see baseball and not robots - thatphotochick [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Turn off safe mode on roboRio?
Hey guys I was updating our roborio to firmware version 3.0.0f0. Somewhere along the way, connection was lost and so we were stuck in between firmware versions. New attempts to flash failed but I could still communicate. I had read about the safe mode so I switched it on via the webserver. Now it always boots onto safe mode. The problem is that in safe mode, it blinks repeatedly indicating a catastrophic error occurred. Does anybody know how I can turn off the force safe mode via the two buttons? Or should I just call National Instruments support when I get a chance?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode