|
|
|
 You can take the man out of FIRST, but you can't take FIRST out of the man.
- George1902 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| You can take the man out of FIRST, but you can't take FIRST out of the man.
- George1902 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Dual stick controlling with a 360 controller
Ok so first year programmer here and im looking for a way to make use of both sticks on the 360 controller. More specifically using one stick to control one set of motors and the other to control the other set. im not new to programming but i am new to LabView. excuse me if there is already another thread about this topic im not very good at searching forums.
thanks in advance guys -Crazykid 
|
|
#2
10-02-2016, 07:48
|
|||||
|
|||||
|
Re: Dual stick controlling with a 360 controller
Just route the wires out of the joystick to the different motors.
Last edited by Mark McLeod : 10-02-2016 at 07:59.
|
|
#3
11-02-2016, 13:20
|
|||
|
|||
|
Re: Dual stick controlling with a 360 controller
Thanks took me a few minutes to figure out I had referenced the drive system instead of motors so the config you gave me wasn't working. But It works now so thanks.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
