|
|
|
 And then since this is GTR-W there's also maple syrup somewhere and the drive team says "Sooory." - PayneTrain [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| And then since this is GTR-W there's also maple syrup somewhere and the drive team says "Sooory." - PayneTrain [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
19-02-2016, 13:57
|
|||
|
|||
|
Re: Hex broaching in thick aluminum stock
would the hex stock go through the walls of the tube in the original design? Or would the hex only insert into the laser cut insert?
If it goes through the walls couldn't you just allow the hex itself to locate the inserts? Then have them cut to fit snug inside the tube and be good? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode