Hex broaching in thick aluminum stock

That's why I have Fantasy FIRST. IT has to make up at least 75% of my posts here. - Koko Ed [more]

		Chief Delphi > Technical > Technical Discussion
Hex broaching in thick aluminum stock

Thread Tools

Rate Thread

Display Modes

#11

19-02-2016, 16:02

bigbeezy

Registered User

AKA: Bryan

FRC #2338 (Gear it Forward)

Team Role: Coach

Join Date: Dec 2006

Rookie Year: 2005

Location: Oswego, IL

Posts: 310

Re: Hex broaching in thick aluminum stock

We have a manual arbor press and broached 1" think 6061 AL this year without a problem. Does take some muscle but not too bad.

__________________
Team 1592 Bionic Tigers -- Driver 2005-2008
Winner - Florida Regional 2005
Finalist - Newton Division 2007
Winner - Colorado Regional 2008
Florida State University - BS Mechanical Engineering
Team 2338 Gear it Forward -- Mentor/Drive Coach 2013-Present
Winner - Wisconsin Regional 2013
Chairman's Award - Midwest Regional 2015
Winner - Archimedes Sub-Division 2015
Chairman's Award - Midwest Regional 2016

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:38.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.