|
|
|
 It's our first time actually doing the math for all of our mechanisms and for some reason math actually works. - Ginger Power [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It's our first time actually doing the math for all of our mechanisms and for some reason math actually works. - Ginger Power [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
19-02-2016, 16:11
|
|||||
|
|||||
|
Re: Hex broaching in thick aluminum stock
Could you it cut instead? Our waterjet sponsor had no issues cutting a 1/2 hex hole through 4 inches of 7075.
Don't know too much about broaching but if your still going to go your current route listen to everyone else above me. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode