|
|
|
 When your team becomes ubiquitous with the phrase "Always a bridesmaid, never the bride" - Peyton Yeung [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| When your team becomes ubiquitous with the phrase "Always a bridesmaid, never the bride" - Peyton Yeung [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
775pro layer peeling off
 Anyone else see this? It's a metallic layer and I'm afraid of it shorting our electronics. I haven't heard of this and I'm sure I would've seen it on here. Last edited by mastachyra : 19-02-2016 at 21:29. 
|
|
#3
19-02-2016, 22:06
|
||||
|
||||
|
Re: 775pro layer peeling off
No, it ran once for a few seconds. It just started peeling and I flaked it off very easily. It looks like all the loose stuff is gone now.
|
|
#4
19-02-2016, 22:11
|
||||
|
||||
|
Hard to tell in pic, but looks like it's just the plating from the band around motor. I would however take a picture showing the numbers so if any more flakes off you can show robot inspector what kind of motor it is. Better to cover your butt than not
|
|
#5
19-02-2016, 22:23
|
||||
|
||||
|
Re: 775pro layer peeling off
Quote:
You should report this to WCP and VEX. They need to know about it.
|
|
#6
19-02-2016, 23:15
|
|||
|
|||
|
Re: 775pro layer peeling off
We had a similar case with one of our 775 pro's. However with ours it arrived like this. There was a semi large section without coating slightly eating into where the numbers are.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
