Cannot Connect to Target while deploying.

The most important part of successfully solving the problem is to understand what the problem is. Elegance in engineering comes from "optimizing" your solution, not solving problems that don't really exist. Fulfill your requirements, meet your goals... - JVN [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Cannot Connect to Target while deploying.

Thread Tools

Rating:

Display Modes

23-02-2016, 07:31

priderobotics priderobotics is offline

Registered User

FRC #5141 (PRIDE Robotics)

Join Date: Jan 2016

Rookie Year: 2016

Location: North Kansas City

Posts: 8

priderobotics is an unknown quantity at this point

Re: Cannot Connect to Target while deploying.

Thanks, Mark. Thanks, Jeff. That worked! We had the target set for the wrong IP. It's working now!

Today we'll try changing the IP on the old roboRIO to roborio-5141-FRC.local so that we know it's following protocol for the competition. (I'm not sure if there's a rule about this or not.)

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 20:46.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.