A question about 8in Bumpers...

Attitudes in one part of life tend to carry over to others. - Wetzel [more]

		Chief Delphi > FIRST > General Forum
A question about 8in Bumpers...

Thread Tools

Rate Thread

Display Modes

#12

02-23-2016, 10:30 PM

Branden2648 Branden2648 is offline

Registered User

FRC #2648 (Infinite Loop)

Team Role: College Student

Join Date: Feb 2014

Rookie Year: 2013

Location: Oakland, Maine

Posts: 22

Re: A question about 8in Bumpers...

One thing I could recommend if possible is to cut the corners at the opposite side of your robot. This will allow you to add metal to either side of the frame thus making the gap between your 8 in. bumpers widen. I also would say to do some math before you do any cutting if you were to go with this method. Hope this helps! Good luck

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:47 PM.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.