four-motor tank drive control

There are times when your team will struggle and there are times when it will achieve great victories. There will be times when unknown and uncontrollable factors will intercede to provide an unexpected outcome for which your team must compensate. - Travis Hoffman [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
four-motor tank drive control

Thread Tools

Rate Thread

Display Modes

24-02-2016, 21:24

C.Barry

Co-Captain

AKA: Courtney

FRC #2723 (Team Rocket)

Join Date: Feb 2016

Rookie Year: 2012

Location: Oklahoma City

Posts: 3

C.Barry is an unknown quantity at this point

Re: four-motor tank drive control

Thank you very much, Mark McLeod.

I was unsure if I could use the Open 4 Motors, as I was under the impression that I needed two refnum names (one for each axis). I did not know you could still use one refnum name and wire the code blocks like that.

Sincerely,
Courtney Barry

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 20:46.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.